Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Collisions on a switch (?)

Hi

Has anyone ever seen a switch interface report collisions? This should'nt happen on a switch as far as I can see.

HW:6513

IOS:12.2.18

1 REPLY

Re: Collisions on a switch (?)

Hi Friend,

Switch port can definetely report collisions when the interface is set to half duplex or if at all it is negotiating to half duplex.

Also if the cable is too long it may report late collisions and also sometim due to physical cable problem collisions are reported.

Check the sh interfce and check for duplex settings and autonegotiation.

Default switch interface are set to autonegotiate and it does not work fine so bette to manual set the full duplex settings.

HTH, if yes please rate helpfull post.

Ankur

275
Views
0
Helpful
1
Replies