I just turned up a Cisco 7513 and I have about 2 PA-8E modules in a VIP 2-50 card. I have servers connected to these ports and I continue to get massive collisions on every port. I attempted to change the config on the PA-8E to Full Duplex but there is no command for that on the interface. Does anyone know if these modules are only half duplex or how to change it to full duplex. Here are a couple of my errors and the int config:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...