Re: Combination of FR PVC Bundles and FR Low Latency Queueing
You can use LLQ along with Frame-relay at the VC level. The service policy defining LLQ can be attached to the DLCI under the map-lass along with the shaping commands for that PVC. PIPQ prioritizes one PVC over the other at the interface level, but I think LLQ when used this way operates within the VC on which it is configured. These docs have more information :
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...