Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Command "switchport port-security violation shutdown"

Hi all,

When use port-security in the switch, we use switchport port-security mac-address x.x.x to config the port, but what's the difference with the "switchport port-security violation shutdown" command? Thank You!

Best Regards

Teru Lei

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Command "switchport port-security violation shutdown"

shutdown—When a port security violation occurs, the interface is error-disabled and the port LED is off. When a secure port is in the error-disabled state, you can bring it out of this state by entering the errdisable recovery cause psecure-violation global configuration command, or you can manually re-enable it by entering the shutdown and no shutdown interface configuration commands. This is the default mode.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080150bcd.html

Nilesh

1 REPLY
Cisco Employee

Re: Command "switchport port-security violation shutdown"

shutdown—When a port security violation occurs, the interface is error-disabled and the port LED is off. When a secure port is in the error-disabled state, you can bring it out of this state by entering the errdisable recovery cause psecure-violation global configuration command, or you can manually re-enable it by entering the shutdown and no shutdown interface configuration commands. This is the default mode.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080150bcd.html

Nilesh

405
Views
0
Helpful
1
Replies