If I perform the following command on a cisco 72xx series, I get an output which is showing me the speed the serial port is getting from the Csu/dsu.
The same command performed on the cisco 17xx; 18xx;26xx;28xx series never showes the clockrate. Is it impossible to get it or there is another way? Since sometimes Ptt set wrong speed on the csu/dsu it could be important check on the router which speed is detecting
7206vxr#sh controller s2/5
M8T-V.35: show controller:
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.35 DTE cable, received clockrate 2047212<<<<<<<<<<<<<<<<<<<<<<<
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...