Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Command to show bus utilization

Hi all,

Anyone know off hand what the command is to show utilization per bus? I'm thinking of sh diag-bus ... can anyone confirm?

Thanks! Blm

3 REPLIES
Cisco Employee

Re: Command to show bus utilization

Which device? On a Cat5000, you can do sh traffic

Cat-5500> (enable) sh traffic

Threshold: 100%

Switching-Bus Traffic Peak Peak-Time

------------- ------- ---- -------------------------

A 0% 0% Thu Jul 11 2002, 14:45:41

B 0% 0% Thu Jul 11 2002, 14:45:41

C 0% 0% Thu Jul 11 2002, 14:45:41

Cat-5500> (enable)

New Member

Re: Command to show bus utilization

I am trying to find a command to sh bus utilization on a Cisco 7513. Can anyone assist by telling what the command is?

thanks.

Cisco Employee

Re: Command to show bus utilization

cs-7513-8a#show controllers cbus utilization

CY0Bus utilization for five seconds: 2%; one minute: 2%; five minutes: 2%

CY1Bus utilization for five seconds: 2%; one minute: 2%; five minutes: 2%

260
Views
0
Helpful
3
Replies
CreatePlease to create content