06-05-2006 12:32 PM - edited 03-03-2019 03:30 AM
I need to see the mac address table in this switch and the command "show mac-address-table" does not exist.
IOS Version 12.0(14)W5(20).
Thanks in advance
06-05-2006 12:46 PM
show mac-address-table is not supported at all on the 2948G-L3. Try show bridge ? and try each option, I belive if you do the show bridge x ? would give you the mac addresses it learned it's bridging.
Please rate helpful posts.
06-05-2006 12:58 PM
may this will help you
regards
Devang
06-05-2006 01:06 PM
http://www.cisco.com/univercd/cc/td/doc/product/l3sw/4908g_l3/ios_12/10w518e/config/guidefmx.htm
http://www.cisco.com/univercd/cc/td/doc/product/l3sw/4908g_l3/ios_12/10w518e/config/index.htm
Above are the software cofigs guides for the 2948G-L3 with a 12.0(14)W5(20) IOS.
I concur that the show bridge command will show you.
Router# show bridge bridge-group-number |
interface address
Display classes of entries in the bridge forwarding database
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide