Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

command to show mac address table in Catalyst 2948G-L3

I need to see the mac address table in this switch and the command "show mac-address-table" does not exist.

IOS Version 12.0(14)W5(20).

Thanks in advance

3 REPLIES

Re: command to show mac address table in Catalyst 2948G-L3

show mac-address-table is not supported at all on the 2948G-L3. Try show bridge ? and try each option, I belive if you do the show bridge x ? would give you the mac addresses it learned it's bridging.

Please rate helpful posts.

Re: command to show mac address table in Catalyst 2948G-L3

New Member

Re: command to show mac address table in Catalyst 2948G-L3

http://www.cisco.com/univercd/cc/td/doc/product/l3sw/4908g_l3/ios_12/10w518e/config/guidefmx.htm

http://www.cisco.com/univercd/cc/td/doc/product/l3sw/4908g_l3/ios_12/10w518e/config/index.htm

Above are the software cofigs guides for the 2948G-L3 with a 12.0(14)W5(20) IOS.

I concur that the show bridge command will show you.

Router# show bridge bridge-group-number |

interface address

Display classes of entries in the bridge forwarding database

1603
Views
0
Helpful
3
Replies