Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

commands for serial interface

What are the commands for changing the line encoding and framing on the serial interface of a 2600 running 12.1 IOS?

Thanks,

Diego

2 REPLIES
Silver

Re: commands for serial interface

Diego,

This is a controller command.. and dependant on HW you'll have different choices. Controller Numbering will change based on interface number as well.

Examples:

Router(config-controller)#framing {esf | sf}. or.

Router(config-controller)#framing {crc4 | no-crc4}

Here's a link with some helpful controller commands:

http://www.cisco.com/en/US/partner/products/hw/routers/ps1904/products_command_reference_chapter09186a008007dbd4.html

Hope this helps,

Don

Re: commands for serial interface

If its a wic with internal CSU/DSU, then you can change it using,

"service-module T1" command

For more info check , http://www.cisco.com/warp/public/471/52.html ( The link is for a 2500 series router, but basically the commands are the same)

If your wic is a wic-1t or wic2t, which needs an external csu/dsu, then you can configure the line encoding and framing, only on the csu/dsu.

81
Views
0
Helpful
2
Replies