Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Commands for Voice configuration on Catalyst Switches

What command I need to configure priority on Cisco 6509 (Layer 3 Backbone Switch) and 20 Cisco 2950 (access switches)?

Each Cisco 2950 switch will have 2 0r 3 port dedicated for Nortel IP Phone to talk to Nortel CSE1000 Server.

I just wan't to make sure that Voice ports have all the priority over Data Ports.

Any design recommendations. Should I create a sepearte VLAN for voice traffic.

Thanks in advance.

3 REPLIES
New Member

Re: Commands for Voice configuration on Catalyst Switches

From what limited I have read is that you would have a voice VLAN and a data VLAN.

New Member

Re: Commands for Voice configuration on Catalyst Switches

There will be multiple VLANS for Data. I will create one sepearte VLAN for voice traffic only, and then want to prioritize my voice traffic over data traffic.

I could not find any good article where I would be able to learn the specific commands for prioritizing voice traffic over data traffic, and that is where I need the help with the commands.

Thanks

New Member

Re: Commands for Voice configuration on Catalyst Switches

84
Views
0
Helpful
3
Replies
CreatePlease to create content