Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Commands to allow MRTG to graph WAN port.

How do I setup up the CISCO 1605R router so that MRTG is able to calculate the WAN port traffic. What commands/syntax do I need to type in and where. Please give me the commands and all the steps to allow MRTG to graph the WAN port. I am a newbie to MRTG, thanks.

2 REPLIES
Blue

Re: Commands to allow MRTG to graph WAN port.

http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/dialsol/nmssol/mrtg.htm can get you started. Also refer to mrtg.org for the user pages as well.

New Member

Re: Commands to allow MRTG to graph WAN port.

Thanks, at long last I've got the MRTG to graph my WAN port which is a good start. But what I really wanted is for a SNMP software such as MRTG to present the traffic as Megabytes every five minutes, 1 hour, 1 day, 1 week, 1 months interval. At the moment MRTG only graphs these intervals but not present the actual figures, is there a MRTG command that allows me to do this??? Or can MRTG be tuned to do it? Or is there other SNMP software that present the figures??

89
Views
0
Helpful
2
Replies
CreatePlease to create content