Commited bandwidth per IP or range of IP on an interface
Can someone please guide me how to implement provisioning of bandwidth per IP or range of IP in support of service level agreement (SLA). Let's say a certain IP will be given a commited bandwidth and burstable bandwidth available on the interface. This method is available on some boxes (other vendor) however i would like to know if this is also possible on a Cisco Router.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...