Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Compatibility of 7606 router with 2950T switch

i have 7606 router installed in the main office.when i connect the gigabit port of the router with the gigabit port of 2950T switch, the gigabit port of router doesnot show up. due to this i am facing lots of problem. please help me out.

4 REPLIES

Re: Compatibility of 7606 router with 2950T switch

Hi Frined,

2950 default settings are dynamic desirable. If you do not want this port to be a trunk port change it to access port with command "switchport mode access" and even if you want it to be a trunk port configure it manually for trunk.

ALso configure both the end with manual speed an duplex settings and if that does not work try with aut auto on both the sides.

HTH

Ankur

Re: Compatibility of 7606 router with 2950T switch

Hi,

Does 2950 show you any light on the port. What doesn show int x/y says you on both the switch and the router. What type of modules you are using and also the type of cable. Please paste the configs.

Try using command " negotiation auto " under the interfaces on your 7606 and also on 2950 gig port.

regards,

-amit singh

New Member

Re: Compatibility of 7606 router with 2950T switch

module used in 7606 router is Supervisor Engine 720-3B. Systimax Cat 6 cable is used

Re: Compatibility of 7606 router with 2950T switch

So you are trying to uplink the switch directly to Sup720. Sup720 has 2 uplink fiber ports, please let me know the GBIC used in both the switches. If you are talking about Cat6 cable taht means you are using 1000bast T GBIC in the sup 720 uplink port and same on the other.

Please paste switch port configs from both the switches and also the output of " show int x/y " from both the switches.

regards,

-amit singh

120
Views
0
Helpful
4
Replies
CreatePlease login to create content