Compatibility of WS-X6148-RJ-21 with CATOS 6.4(4A)
I've few Cat6509 running with WS-X6K-SUP1A-2GE and WS-X6248A-TEL. I've purchase the WS-X6148-RJ-21 to replace the EOL WS-X6248A-TEL. However, I'm not sure is WS-X6148-RJ-21 compatible with Sup1A and CATOS 6.4(4A) Kindly advise.
And the other way is to use software advisor from Cisco that can tell the software requirement of particular hardware. Or use configuration tool to setup the whole system and verify the compatibility between modules, sup, CatOS, etc.
You can search Cisco web for these kind of information.
Re: Compatibility of WS-X6148-RJ-21 with CATOS 6.4(4A)
You're welcome. What I think the Sup 1A is too old that it is EoS, so it can't be find in configuration tool. You can also check the module installation doc. that will also indicate the requirement. Moreover, you have to check will Sup1A & other existing modules support this new module.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.