04-20-2006 02:15 AM - edited 03-03-2019 02:52 AM
I need to throw some questions and concerns out to this forum for piece of mind advice. I have a 6509 with Sup1a boards (redundant). I purchased MSFC daughter boards for both of them and I want to add them to the Sup1a boards. Are there any major concerns I need to know about? I plan on removing the standby board adding the MSFC and inserting it back in the chassis. From there I was going to pop the active board (I know an outage will occur) and add the MSFC to the other board. Upon completion I was going to check out the MSFC's to see if they come up OK... With all that said, are there any hidden items or concerns that I would probably need to look at or be prepared for??? Thanks....
Solved! Go to Solution.
04-20-2006 02:32 AM
Hi Friend,
Have a look at this link which will guide you with all the procedures and installation guide
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm#35508
HTH, if yes please rate the post.
Ankur
04-20-2006 02:32 AM
Hi Friend,
Have a look at this link which will guide you with all the procedures and installation guide
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm#35508
HTH, if yes please rate the post.
Ankur
04-20-2006 03:35 AM
Thanks..Just what I was looking for....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide