Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Silver

Concerns about adding MSFC to my 6509

I need to throw some questions and concerns out to this forum for piece of mind advice. I have a 6509 with Sup1a boards (redundant). I purchased MSFC daughter boards for both of them and I want to add them to the Sup1a boards. Are there any major concerns I need to know about? I plan on removing the standby board adding the MSFC and inserting it back in the chassis. From there I was going to pop the active board (I know an outage will occur) and add the MSFC to the other board. Upon completion I was going to check out the MSFC's to see if they come up OK... With all that said, are there any hidden items or concerns that I would probably need to look at or be prepared for??? Thanks....

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Concerns about adding MSFC to my 6509

Hi Friend,

Have a look at this link which will guide you with all the procedures and installation guide

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm#35508

HTH, if yes please rate the post.

Ankur

2 REPLIES

Re: Concerns about adding MSFC to my 6509

Hi Friend,

Have a look at this link which will guide you with all the procedures and installation guide

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_10605.htm#35508

HTH, if yes please rate the post.

Ankur

Silver

Re: Concerns about adding MSFC to my 6509

Thanks..Just what I was looking for....

108
Views
0
Helpful
2
Replies
CreatePlease to create content