Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Conditional NAT

Hi all,

Is it possible to do conditional destination NAT as follows:

IF

SOURCE = NETWORK X AND DESTINATION = IP ADDRESS Y

THEN

NAT DESTINATION IP ADDRESS Y TO DESTINATION IP ADDRESS Z

I've tried all kinds of NAT/access-lists/policy routing to get this working but

have run out of ideas...

thanks,

Andrew.

4 REPLIES
Silver

Re: Conditional NAT

Hi Andrew,

In my opinion, I don't think it would be possible to do this.

Re: Conditional NAT

Not sure if this is what you had in mind but take a look at: http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087bac.html

eg.

ip nat inside source static 11.1.1.2 192.68.1.21 route-map isp2

ip nat inside source static 11.1.1.2 172.68.1.21 route-map isp1

ip nat inside source static 11.1.1.1 192.68.1.11 route-map isp2

ip nat inside source static 11.1.1.1 172.68.1.11 route-map isp1

access-list 101 permit ip 11.1.1.0 0.0.0.255 172.0.0.0 0.255.255.255

access-list 102 permit ip 11.1.1.0 0.0.0.255 192.0.0.0 0.255.255.255

!

route-map isp2 permit 10

match ip address 102

set ip next-hop 192.68.1.1

!

route-map isp1 permit 10

match ip address 101

set ip next-hop 172.68.1.1

Hope it helps.

Steve

New Member

Re: Conditional NAT

I implemented this goal two years ago using a c3640.But when you route-map,there is some problem with the NAT for some applications.Maybe cisco i has fixed these bugs.

New Member

Re: Conditional NAT

thanks Steve,

This is exactly what I was looking for. Now for the real challenge - getting an IOS upgrade through change control!

cheers.

249
Views
8
Helpful
4
Replies