Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
364
Views
0
Helpful
2
Replies

Config C2600 Router to bridge Ethernet and Tokenring on same subnet - how?

brunske
Level 1
Level 1

‎03-20-2003 06:29 AM - edited ‎03-02-2019 06:00 AM

Hi - can anyone advise as to the best configuration to apply to a C2600 router in order to bridge layer 2 traffic between ethernet and token ring on the same subnet?

cheers

Erik

Labels:
0 Helpful
2 Replies 2

rwiesmann
Level 4
Level 4

‎03-20-2003 08:25 AM

Hi Erik

You need source-route translational bridging (SR/TLB).

Check the link below and search for SRB, it is the config guide:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ibm_c/bcprt1/bcdsrb.htm

Hope that helps.

Roger

0 Helpful

brunske
Level 1
Level 1
In response to rwiesmann

‎03-20-2003 08:42 AM

Thanks Roger

Erik

0 Helpful
Customers Also Viewed These Support Documents