Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Config C2600 Router to bridge Ethernet and Tokenring on same subnet - how?

Hi - can anyone advise as to the best configuration to apply to a C2600 router in order to bridge layer 2 traffic between ethernet and token ring on the same subnet?

cheers

Erik

2 REPLIES
Bronze

Re: Config C2600 Router to bridge Ethernet and Tokenring on same

Hi Erik

You need source-route translational bridging (SR/TLB).

Check the link below and search for SRB, it is the config guide:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ibm_c/bcprt1/bcdsrb.htm

Hope that helps.

Roger

New Member

Re: Config C2600 Router to bridge Ethernet and Tokenring on same

Thanks Roger

Erik

141
Views
0
Helpful
2
Replies
CreatePlease to create content