I'm about to install a 2500 router with 2 eth and 1 serial connection to a CSU/DSU full T1. question is do I have to set the clock rate on the serial link since its connecting to the CSU, and is there an transiever for the serial interface to run over cat6 cable? The only output of the csu/dsu is a rj-45 jack.
now the config question.
I'm going to use NAT on the internal network and the serial ip address is 184.108.40.206 255.255.255.0 with a default gateway of 220.127.116.11 or something or other. I'm going to set the internal IP's at the normal 192.168.1.0 that everyone knows and loves.
the static config of this set-up would look something like this
ip route 0.0.0.0 0.0.0.0 18.104.22.168 s0
this is basically establishing my gateway on the s0 int? If you see anything wrong with this please let me know. I appologize for such an easy question but I've been working in layer 2 almost exclusively for the last year and my layer 3 abilities have suffered.
I' sure about the mask on the serial int. I found it odd that the ISP would give me the IP that they did also. The csu/dsu is completely installed already the ISP installed it and ran to the loop. I'm basically setting up the internal net.
I haven't seen a WIC card for the 2500 that supports a rj-45 terination, is this WIC available or do I have to use a transiever.
Are you sure that your "CSU" is a CSU? Sounds like a smart jack since it only has RJ-45. If it were really a CSU it would have an EIA-530, V.35, etc. interface for the drop side. A WIC will not interface directly to a Smart Jack. A true CSU would be required.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.