Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

config port security on 3548s

I am wondering if there is an easier way for me to set port security on multiple ports at once than one at a time with 3548s. I know with 3550 you can use the "interface range" command to accomplish this from config mode.

I tried using the CNA which allows you to highlight multiple ports but there's a problem setting meximum address count over 1. I'm trying to limit them to 2 but it won't let me save if I choose any number higher than 1. However doing it fomr command line works...

1 REPLY
Silver

Re: config port security on 3548s

I think, its a limitation in the 3548's... as you had mentioned, this can be done in the Catalyst 3550 using the "interface range" command.

113
Views
0
Helpful
1
Replies