Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Config Problem ?

Here is my network architecture:

LAN1---R1--tunnel---R2---Public LAN--R3----ISP

R4-------------------------------------

|

|

LAN2

PCs on Lan2 go to Internet via ISP.

Servers on Public LAN are accessible from Internet.

R2 use the secondary address of R3 as gateway.

PCs on LAN1 can ping addresses on Internet but they cannot browse corresponding websites.

Other websites can be browsed.

R2 and R4 perform NAT.

What is the problem?

Thanks

1 REPLY

Re: Config Problem ?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

109
Views
0
Helpful
1
Replies
CreatePlease to create content