Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config-Register

I have been going through the config-register and I know the following to be true:

0x210X = 9600 baud

0x212X = 19200 baud

0x312X = 57600 baud

0xXXX0 = ROM

0xXXX1 = Bootstrap

0xXXX2 = Normal

The problem is the ignore value of 0x2142.

My question is "Does anyone know why it is 0x2142?"  If 2 is normal NVRAM then does that mean that the prefix of 0x214X is the ignore value?  What is special about it?  I am just really curious about how this value was selected to be the ignore value.  If anyone knows of any resources about config-register values and how they relate please let me know.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Config-Register

0xXX2X = bit 5 set = 19200

0xX8XX = bit 11 set = 4800

0x1XXX = bit 12 set = 1200

See also http://www.cisco.com/en/US/docs/routers/access/1800/1841/software/configuration/guide/b_creg.html, Table 4.

When all bits are cleared (0) it is the default rate of 9600.

4 REPLIES
New Member

Re: Config-Register

Someone just replied to another post on another site.

The value of 0xXX4X is the ignore NVRAM Value.

here is the link i was looking for:

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

New Member

Re: Config-Register

I have a new question now.

In that document I see the following:

5,11,12

0x0020, 0x0800, 0x1000

  • Console line speed

However it says that 0x2902 has a baud rate of 4800.  So I broke up the hex into the following:

0x0100 = no break

0x0800 = speed/baud rate

0x2000 = boots rom on failure

0x0002 = normal boot

-----------

0x2902


This tells me that 0x0800 is a 4800 baud rate, but that doesn't match what I was expecting.

The only explaination I can think of is the following:

if speed = !

     speed = 9600

elseif speed = 0x0800

     speed = 4800


or something very close to this.  Without me crunching the numbers to verify does anyone know what baud rates you get from 0x0020, 0x0800, and 0x1000?

Cisco Employee

Re: Config-Register

0xXX2X = bit 5 set = 19200

0xX8XX = bit 11 set = 4800

0x1XXX = bit 12 set = 1200

See also http://www.cisco.com/en/US/docs/routers/access/1800/1841/software/configuration/guide/b_creg.html, Table 4.

When all bits are cleared (0) it is the default rate of 9600.

New Member

Re: Config-Register

Thanks Phillip.  I suspected that was the case.  Thank you for helping me locate what the bits would result in.

.

716
Views
0
Helpful
4
Replies
CreatePlease to create content