Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

[Config] WAN to LAN mapping

Hi There.

I am looking for a way to map a host on the LAN side to a WAN IP directly so that all requests to all ports on this IP address would be routed to it. All that on a Cisco 1750 that runs NAT for the rest of the network.

Thanks

Amir

2 REPLIES
Bronze

Re: [Config] WAN to LAN mapping

Amir,

Use the global configuration command "ip nat inside source (inside address) (outside address)".

HTH

Mark

Community Member

Re: [Config] WAN to LAN mapping

Thanks.

The problem is that I'm trying to set some software that needs to have the WAN IP address. So NAT won't work for me. I have to somehow place it on the DMZ.

I can't seem to find a way to do it without adding a card (WIC-1ENET)to the router.

Thanks again

Amir

109
Views
0
Helpful
2
Replies
CreatePlease to create content