The above process does not seem to start automatically on boot on my lms 4th edition server. This causes problems when a config change takes place. Is this process supposed to start on startup of the other LMS processes? If not can this be set to auto start?
This is a transient process, which means it runs 'on demand' only. I'm not sure by which process or action it is invoked, but it might be Schedule Collection or Update Inventory in RME's Inventory, which you can schedule yourself. In RME's Change Audit, you should see 'all' changes made in your network devices. Apart from that, you can arrange that device configurations are automatically archived when a change occurs: see General Setup in Configuration Management. This archiving is great, but does not always work for all devices...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...