Configuration Examples of WAVE Inline implementations
I am implementing the first inline WAE device in our network. But I am having difficulties finding examples of how the WAVE-294-K9 should be initially setup in preparation to register with the Central Manager.
I think I have a general idea of how it is supposed to work. But I would like some examples to base my final decision on.
I have not been able to find in the docs where it describes where the primary interface should be located. Below is how I understand the inline should be connected, please advise on configuration or possible other options. Thanks! Rich
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...