Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuration for ICC-T1 when used in an NFAS Group

Configuration for ICC-T1 when used in an NFAS Group

1 REPLY
Anonymous
N/A

Re: Configuration for ICC-T1 when used in an NFAS Group

This is applicable on Releases 5.1.4 and 5.2.0 of the VCO4K software.

When used in an NFAS Group, ICC-T1s must be configured with SPAN_TYPE = SF_NR or ESF_NR depending on whether the controlling ICC-PRI Spans are set to SF or ESF respectively.

This disables Robbed-Bit signaling

on the ICC-T1. Setting SPAN_TYPE to either SF or ESF causes a

significant reduction in the call load that a single ICC can handle.

This in turn reduces the total call load capacity of the switch

111
Views
0
Helpful
1
Replies
作成コンテンツを作成するには してください