Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration for two 1600 routers with 56k DSU back-to-back in DDS mode.

I've used a cross-over cable to connect the two routers and using the service-module configuration, but one of the routers would not take the service-module clock rate command. Therefore, the link never came up. Any suggestions.

Thank you!

Louis

1 REPLY

Re: Configuration for two 1600 routers with 56k DSU back-to-back

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

114
Views
0
Helpful
1
Replies
CreatePlease to create content