we have a netscreen firewall at the centre.there are 4 zones configured viz.user zone , user1 zone,serverfarm,wan zone and DMZ.these zones have 2950 switches.these switches are connected to firewall how to configure etherchannel on these switches??
i want to configure it both between firewall and switch and between server and switch becoz if etherchannel is not created between firewall and switch then user zone will not be getting higher bandwidth as each and every traffic is to pass through firewall to reach desired zone.....help me out...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.