Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuration of NBAR for ATM WAN Links ?

Hello together,

i like to configure NBAR for our ATM WAN Links or our ATM LANE.

Has anbody experience for this issue and can provide a sample configuration ?.

I want to try the "ip nbar protocol-discovery" command but this is not listed in interface configuration mode.

I try to do this on a Cisco 7507 Router with RSP-jsv-mz.12-1.14 as IOS.

Thanks for your help.

1 REPLY
Bronze

Re: Configuration of NBAR for ATM WAN Links ?

You need to enable Cisco Express Forwarding (CEF) in order to use NBAR in the interface.Also check whether your version of software supports NBAR, check the following links

http://www.cisco.com/en/US/products/hw/routers/ps359/products_tech_note09186a00800fc176.shtml

http://www.cisco.com/en/US/tech/tk39/tk824/technologies_configuration_example09186a0080094ad1.shtml

94
Views
0
Helpful
1
Replies
CreatePlease to create content