configuration of prvilege levels in catos 7.6

[luciano.carvalho]

hi all,

I'd like to configure a catalyst 6509 switch running catos 7.6 to use authentication local and create users with differente level of privilege.

set localuser user cisco password cisco privilege 15

set localuser authentication enable

set authentication enable local

But I haven't found the command to add commands to a privilege level like "privilege exec level 0 copy" in IOS software.

Any tip?

[pkhatri]

AFAIK, you cannot customise privilege levels on the Cat6509 running CatOS. You can only have a privilege level of 0 or 15. In fact, when you enter the 'set localuser...' command, you are only given the option of entering a privilege of 0 or 15.

Hope that helps - pls rate the post if it does.

Paresh