If you have your 2620 connected via ethernet or via a serial connection, telnet to the router and change the speed on your console port back to 9600. This will change your config register back to 0x2102.
The router doesn't have a working config, all the interfaces are not configured and there are no passwords configured. I can connect to the router via the AUX port but only to the User mode since no enable password is configured.
hoooooo! This is very OLD post though, but I found it "not answered yet!" .. acutally I landed here after googled exactly the same problem with my 2620. I found the solution for a part of it. You can console into the router using the exact same terminal prametters you used to Xmodemed your IOS file==> Bitrate = 115200
Parity = none
It works for me.
On the other hand, the router actually stuck at the 0x3922 register value, even if you cahnge it via ROMON for 0x2102 it will return back to 0x3922 after the 1st reload. The same issue exist when using the:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.