06-08-2006 09:31 PM - edited 03-03-2019 03:34 AM
I want to run/configure Rapid Spanning Tree Protocol (RSTP) on my network topology (pls. see word file as attachment)...
Can anyone help me...
Shahid
06-09-2006 04:42 AM
Check out this doc...
http://www.cisco.com/warp/public/473/146.html
should find all the info you need in there.
HTH,
Dan
06-09-2006 06:13 AM
Should be pretty straight forward...
I'll recommend you
- explicitly assign your STP priority ..
- make Core Switch 1 your STP Root...
- make core switch 2 your next root candidate.
you should end up with all ports in FORWARDING state except one of the two ports on Switch 2 that are connected to Switch 1 in BLOCKING state (Alt. Port).
HTH.
Eric
06-11-2006 08:11 PM
Dear Eric, thanks for the reply.
I am not very much familiar with Cisco commands...reg. RSTP i just know this command only i.e. "spanning-tree mode rapid-pvst"...
Can you write down Switch-wise commands? It will be very help ful for me...
regards,
Shahid
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: