Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Configuration reqd...pls. help me...

I want to run/configure Rapid Spanning Tree Protocol (RSTP) on my network topology (pls. see word file as attachment)...

Can anyone help me...

Shahid

3 REPLIES
New Member

Re: Configuration reqd...pls. help me...

Check out this doc...

http://www.cisco.com/warp/public/473/146.html

should find all the info you need in there.

HTH,

Dan

New Member

Re: Configuration reqd...pls. help me...

Should be pretty straight forward...

I'll recommend you

- explicitly assign your STP priority ..

- make Core Switch 1 your STP Root...

- make core switch 2 your next root candidate.

you should end up with all ports in FORWARDING state except one of the two ports on Switch 2 that are connected to Switch 1 in BLOCKING state (Alt. Port).

HTH.

Eric

New Member

Re: Configuration reqd...pls. help me...

Dear Eric, thanks for the reply.

I am not very much familiar with Cisco commands...reg. RSTP i just know this command only i.e. "spanning-tree mode rapid-pvst"...

Can you write down Switch-wise commands? It will be very help ful for me...

regards,

Shahid

94
Views
0
Helpful
3
Replies
CreatePlease to create content