Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuration required in Cat 4006 to forward errors to syslog server

Hi,

I have setup a Kiwi syslog server. I want to configure in my Cat 4006 switch to forward the following messages to my syslog server

1. configuration changes

2. Vlan creation /modification

3. Power supply failures/module failures/temperature

4. When the processor utlization exceeds more than 75% , it should send a alert message to syslog server

5. Switch restart

6. Trap for any changes in Uplink ports only. There are 4 uplinks to other Switches from 4006. If any problem with these ports (uplink), it should send message to syslog server , not for all ports

Thanks in advance

Raju

2 REPLIES

Re: Configuration required in Cat 4006 to forward errors to sysl

Hi

I feel this link will be of some help to u in configuring different severity levels for different facilities available.

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800d81c8.html

By default for abnormal temp conditions u will get logs in the syslog server if u have already pointed the logs to the syslog server..

regds

New Member

Re: Configuration required in Cat 4006 to forward errors to sysl

Thanks edwin. It was a useful link.

Regards,

Raju

FSS

120
Views
0
Helpful
2
Replies