Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configure 3810 MFT from T1 to E1

How to change the 3810 MFT Trunk from T1 to E1 or vice-versa without changing hardware.

1 REPLY
Anonymous
N/A

Re: Configure 3810 MFT from T1 to E1

Procedure Mentioned below is applicable on all IOS versions above 11.3(1)MA1

Procedure:

1. go to enable mode

2. configure terminal

3. change register to 0x0

4. write to memory

5. reload will bring the router into rommon mode

6. type in "trunk E1" then hit Enter (trunk T1 if vise versa)

7. type "confreg 0x2102"

8. type "reset"

9. the router should reboot and change MFT trunk to E1.

118
Views
0
Helpful
1
Replies
CreatePlease to create content