Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure a WIC for primary

Hello, i must configure a 2610 with IOS 12.2(8)T that have a WIC 1MTF-G703 to receive incoming calls, but I no have idea.

Can anybody help me, please?

2 REPLIES
New Member

Re: Configure a WIC for primary

What kind of calls are you trying to receive?

Voice, data, analog, digital, .....

is this over a T1, or a PRI ....

is it supposed to forward to a PBX, internal modems, .....

~rlc

CCNP, CCDA, CNE

Cisco Employee

Re: Configure a WIC for primary

You can receive the incoming voice calls over that VWIC-1MFT-G703, which is 1-Port RJ-48 Multiflex Trunk - E1 for unstructured G.703, from PSTN.

Here is the link which talks about the features supported on that card

http://www.cisco.com/warp/public/788/products/vwicmf_e1.html

Here is the link which explains how to configure that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t7/t1_mf_t6.htm

After that depending on the network setup, you need to configure dial-peers etc For that here is the link which will help you for that

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113t/113t_1/voip/examples.htm

81
Views
0
Helpful
2
Replies