Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configure MSFC for MLS

Hi,

I have a Cat6509 with MSFC. I have configured the internal router with Interface vlan <number> and assigned IP addresses and no shut commands.

I am able to route between VLAN's with this. We have deployed VTP.

I would like to configure MLS now, I know the 6509 comes enabled with MLS as default, if I enable MLS on the Router (session 5, then mls rp ip) will that enable MLS for all my logical vlan interfaces? Also, do I need to specify my VTP information on the Router? If so, on what interface? Do I also need to specify what interface will send MLSP messages?

My configuration if the above (totally wrong im sure) would look like

Router(config)#mls rp ip

Router(config)#interface vlan 103

Router(config-if)#mls rp vtp-domain AON

Router(config-if)#mls rp management-interface

Is the above enough? I can then set aging times and also my flow masks on the Switch itself.

If someone can explain, that would be appreicated. I've never configured such a device before :) but I understand the concepts of MLS and Intervlan routing (i think)

1 REPLY
New Member

Re: Configure MSFC for MLS

Hello,

you do not need configure anything on the 6500 to have MLS enabled.

You can look at the following link to get more informations :

http://www.cisco.com/warp/public/473/35.html

74
Views
0
Helpful
1
Replies