Configure NAT for sockets from inside server to internet clients?
Can I open up a socket directly to an internet client from inside the firewall?
We want to implement an asynchronous protocol via HTTP between our internet clients and a server inside the firewall. The client will send a request via HTTP (including his own ip address, fire and forget), the server does some processing, and when the results are ready the server will open up a direct socket connection to the client to tell the client the results are ready, so he can pick them up from the server with another HTTP request.
Is this possible? Can the NAT be configured that way?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...