09-02-2003 10:13 AM - edited 03-02-2019 10:02 AM
I have two 2621 routers that I have installed 4 vwic-2mft-t1 cards, 2 in the chassis slot and 2 the network module slots. When I do a Show controller T1 I see, T10/0, T10/1, T10/2, T10/3. I do not see the T11/0, T11/1, T11/2, T11/3 for the cards the network Module slots. Is there anything I need to do to enable these slot to see the Vwic card. I have reseated the cards and reboot the routers. Any suggestions would be apperciated.
Thanks
09-03-2003 03:02 AM
Hi scline,
which network module and IOS version do you use?
Check http://www.cisco.com/warp/public/116/t1_wic4.html if they are compatible, or if you need to upgrade your IOS.
hth
Herbert
09-03-2003 03:58 AM
Hi, Herbert, I amd using NW-2W and IOS Version 12.2(13)T3. The link you provided show that they are support in the 2621xm module that I am using.
Thanks
01-09-2004 11:50 AM
Did you ever figure out why the 2MFT cards in the NM were not functioning correctly?
I also had a asked a question on this forum about configuring 2MFT-T1 VWIC's and was hoping you might be able to take a look at it. :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide