Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring a 2Mbps serial port in Simplex mode

Hi,

I'm using a modem satellite with a VSAT in simplex mode on a 2Mbps serial port on a 3640.

I see on the interface a lot of input errors but no output errors, I think it's due to the way the port is used with the satellite modem, in simplex mode : the port is not receiving any signal from the satellite modem in input.

I'm right ?

Can I configure the serial port to work in simplex mode (just in output) ?

Thanks in advance.

Feth.

1 REPLY
New Member

Re: Configuring a 2Mbps serial port in Simplex mode

hi

iam not sure this may help you

but u can try

ignore-dcd

if you are trying uplink from this router and downlink from sat

this may help you

best of luck

hari

125
Views
3
Helpful
1
Replies
CreatePlease to create content