Please I need some help with a 1601 router serial 0 is connected to x.25 network layer 2 is up but I am getting diag code of 64 in the call setup. What I'm trying to do is route the x.25 data over asyn serial line using ddr. I thought x25 over tcp would work with xot command, but I can't even get the virtual circuit to come up.Below is my config. Thanks a bunch.Erica.
Thanks for your response this is my first attemp at x.25 and xot so I really appreciate your help. S0 on my 1601 is directly connect to XO communication x25 network, typically they will initiate the the callout and transmit data. Now the data coming in I need to send over asyn serial1 to tcp network. In your example here I assuming this is the config for the interface directly connected to the x25 network. I see you have an ip address but no x.25 address so does that mean the x25 address is actually assign to the far end of the xot. Also in this route (x25 route 4646006.* xot ( 10.x.x.x)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.