Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

configuring a switch

I have a Catalyst 2950 Switch, and I was wondering if it is possible to configure the switch to disable a port automatically, if it is broadcasting or recieving too much data, thereby clogging up the rest of the switch. Please let me know if there is any software, or even hardware, that I can install to rectify this problem. Thank you very much.

1 REPLY
New Member

Re: configuring a switch

use the "storm-control broadcast level xx" and "storm-control action shutdown" to disable to port when the broadcast traffic meets the xx Utilization

90
Views
5
Helpful
1
Replies
CreatePlease to create content