08-26-2003 04:54 AM - edited 03-02-2019 09:53 AM
Hi all,
Is it possible to configure the VWIC-2MFT-G703 interface for ATM on the 2621XM IOS 12.2(8)T10?
The command reference for 12.2T says that using the command mode atm (aim | cas) will remove any channel-groups on the E1 controller as the ATM interface uses all channels and create an ATM0 interface.
I have tried this and the interface is not created and no command relating to atm is shown in the sh run output under the controller config.
Is it possible to configure this with out an AIM module on the 2621XM? Or am I missing something?
Any help is much appreciated.
Thanks,
Niels
08-30-2003 03:33 AM
No, the VWIC-2MFT-G703 is not an ATM card, and
cannot perform ATM segmentation and reassembly. It
can be used as a channelized (nx64 kbps) E1, and
also in unframed mode (2048 kbps).
You either need the VWIC-2MFT-G703 in combination
with an AIM, or you need a separate ATM card (e.g.
NM-4E1-IMA).
08-31-2003 10:48 PM
Hi Steinar,
Thanks for your reply. I have looked at the AIM-ATM card and it seems to be what I need.
Cheers,
Niels
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide