Can I configure CCS/CAS on Router serial interface...I've a cisco router with V.35 serial interface that's connected to a V.35/G.703 converter and then connected to a G.703 E1 port of FRSM Card in MGX 8850.
Everything go well when I confgiure the FRSM port as clear and E1 become up but when i configure it as CAS/CCS ...it come down.
So is there anyway to Configure CCS or CAS on Router serial interface.
Re: Configuring CCS or CAS on Router serial interface
When the older motherboard (SCB 6.06) is used with this feature, serial port 1 cannot be used. When the new motherboard (SCB 6.07 and later versions) is used, serial port 1 can be used in DCE mode only.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...