configuring dialling in on an e1 line using a c e1 controller on a 3640
i am trying to configure a 3640 fitted with a channelized e1 controller to allow remote users to dial in . The users dial in over analogue lines to the central office from which i have an e1 line to the router . I succeeded in bringing up the interface but whenever i try to call the number i get a busy tone . The config is as below shown
controller E1 0/0
channel-group 0 timeslots 1-15
controller E1 0/1
no ip address
klapm8# sho controller e1
E1 0/0 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
Data in current interval (307 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.