05-11-2006 02:28 AM - edited 03-03-2019 03:10 AM
We have 2 nos Cisco 6509 switches with MSFC II . VLAN's are configured in both the 6509's and now we need to have the HSRP for redudancy.
05-11-2006 02:35 AM
Hi,
Try something like this
Switch1
interface Vlan100
description VLAN100
ip address x.x.x.252 255.255.255.0
standby 1 ip x.x.x.254
standby 1 authentication Somepassword
Switch2
interface Vlan100
description VLAN100
ip address x.x.x.253 255.255.255.0
standby 1 ip x.x.x.254
standby 1 authentication Somepassword
/Daniel
05-11-2006 11:06 AM
Hi ,
In addition to above post , in the active switch u have to add " standby preempt" .If in any case active switch_1 goes down , standby switch_2 will become active. Now when switch_1 comes up again so to make this switch_1 again active u have to enter this command .If you dont enter this command switch_1 when comes up will remain in standby mode only.
HTH
regards
Abhishek
05-12-2006 04:47 AM
i du agree with watt abhisek says,
this is the working configuration which i am using it in my organisation. hope this will solve ur issue.
Cisco-6509 switch 1
interface Vlan2
description ***SERVER***
ip address 192.168.1.2 255.255.255.0
standby 2 ip 192.168.1.1
standby 2 timers 5 15
standby 2 priority 108
standby 2 preempt
Cisco-6509 switch 2
interface Vlan2
description ***SERVER***
ip address 192.168.1.3 255.255.255.0
standby 2 ip 192.168.1.1
standby 2 timers 5 15
standby 2 priority 109
standby 2 preempt
Rate this post
05-15-2006 08:10 AM
Dear Anand,
It is really helpfull info for me also.I am having same set up But my one 6509 again connect to tw0 3725 routers where i am using HSRP.Please fine set up below
Customer end Router --- > Ethernet1------> 6509-A ---->3725 Router-1 (Standby 3725 Rou-2 )---> Remote Location
Customer end Router --- > Ethernet2------> 6509-A ---->3725 Router-1 (Standby 3725 Rou-2 ) ---> Remote Location
My Problem is that i need full redundancy between customer router and 3725 routers also.
If i cross connect 3725 Routers on both 6509 then how existing HSRP of 3725 will work.
TIA
Regards
SAM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: