Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring internal access on a Cisco 700 router connected to the Internet

I have a customer who needs access into their LAN via their ISDN Cisco 700 router connected to the Internet. The client ISP can provide the Class C ip address. I believe that an ip route is necessary via a subinterface i.e ip route x.x.x.x.x 255.255.255.0 192.168.1.10., however I am not sure of the specific command to make this happen.

  • Other Network Infrastructure Subjects
1 REPLY
Silver

Re: Configuring internal access on a Cisco 700 router connected

The 700 series of routers use set based commands.

So the command that is used to configure a static route is:

SEt IP ROUTE DEstination network [/bits] GAteway nexthop [PRopagate ON | OFf ] [COst value]

You can refer to the command reference for details.

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/750/700cr44/700crip.htm

86
Views
0
Helpful
1
Replies