Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Configuring IP for AP 1242AG

Hi,

I'm new with Cisco hardware, but I have 2 AP 1242AG and I need to change there ip address.

I have tried IPSU and the console option but steel can't change it.

Can someoen please explain the steps to do it?

Thanks,

Paulo Ferreira

1 REPLY

Re: Configuring IP for AP 1242AG

Hi Paulo,

normaly thr IP is set on interface BVI1. I would say try it at the console.

I think you use a user with the correct privelege level. check this if it will not work.

as admin you should use privilege lever 15 ..

conf t

interface bvi1

ip address .......

Or post me the config.

regards,

Sebastian

622
Views
0
Helpful
1
Replies
CreatePlease to create content