Configuring IP Interface to accept DHCP assigned address from ISP with DSL
I have a Cisco 1720 router with a WIC 1-Enet module that I need to configure so that it will accept a DHCP assigned IP address from my ISP using a DSL connection and PPOE. The ISP drops the connection every 24 hours (for security purposes) and requires the connection be reestablished in order to get a new IP address. Can you help by giving me a list of the configuration commands required?
To get dynamic ip address allocated by isp, you need to have "ip address negotiated" under the "interface dialer 1" which is linked with the "interface ethernet0"..That way 1700 will demand ip address from isp during ppp negotiaton phase (IPCP) which will be assigned to dialer interface linked to ethernet...Tejal
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...